Epson FX-880+ 매뉴얼 - 페이지 13

{카테고리_이름} Epson FX-880+에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson FX-880+ 18 페이지. Epson serial impact dot matrix printers
Epson FX-880+에 대해서도 마찬가지입니다: 설정 매뉴얼 (33 페이지), 브로셔 및 사양 (24 페이지), 사양 (2 페이지), 먼저 읽어보기 (2 페이지), 참조 매뉴얼 (34 페이지), 빠른 매뉴얼 (33 페이지)

페이지 인쇄

Switching Paper Types

You can easily switch back and forth between printing on

continuous paper with a push tractor and printing on single

sheets without having to remove or reload the continuous

paper.

Switching to printing on single sheets

Follow the steps below to switch from printing on continuous

paper from a push tractor to printing on single sheets.

If continuous labels are loaded in the printer, remove

them before switching to single-sheet printing.

If the tractor is in the pull position, remove any

continuous paper from it before switching to

single-sheet printing.

1. If any printed pages remain in the printer, press the

button to advance the paper to the tear-off

Tear Off/Bin

position. Then tear off the printed pages.

Make sure you tear off your printed document

before you press the Load/Eject button in the

next step. Reverse feeding several pages at a

time may cause a paper jam.

2. Press the

button to feed the continuous paper

Load/Eject

backward to the standby position. The paper is still attached

to the push tractor but is no longer in the paper path.

3. Lower the continuous paper support on the paper guide

until it clicks into place, then move the paper guide to the

upright position.

4. Set the paper release lever to the single-sheet

position.

5. Load single sheets.

Switching to printing on continuous

paper

Follow the steps below to switch from printing on single sheets

to printing on continuous paper with a push tractor.

To switch from printing with the optional front sheet

guide to printing with the front push tractor, you need

to remove the front sheet guide.

1. If a single sheet remains in the printer, press the

button to eject it.

Never use the knob to eject paper when the

printer is on; this may damage the printer or

cause it to lose the top-of-form position.

2. Make sure the tractor is installed in the front or rear push

position and that continuous paper is loaded on it.

3. Set the paper release lever to the front or rear push position,

depending on the tractor position you are using.

Your printer loads the continuous paper automatically when

you begin printing.

Clearing Paper Jams

Follow these steps to clear a paper jam:

1. Turn off the printer.

2. Open the printer cover.

3. If continuous paper is jammed in the printer, tear off the

fresh supply at the perforation nearest the paper entry slot.

4. Turn the knob on the left side of the printer away from you

to remove the paper in the printer. Remove any remaining

pieces of paper.

5. If the paper is stuck where the printer ejects it, gently pull

the paper out of the printer.

6. Close the printer cover and turn on the printer. Make sure

the

Paper Out

off.

Load/Eject

10/01

EPSON FX-880+/FX-1180+

Use the knob on the left side of the printer to

clear paper jams only when the printer is off.

Otherwise, you may damage the printer or

change the top-of-form or tear-off position.

light is not flashing and the

EPSON FX-880+/FX-1180+

light is

Pause