Epson LQ-570e 제품 지원 게시판 - 페이지 10

{카테고리_이름} Epson LQ-570e에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson LQ-570e 16 페이지. Epson serial impact dot matrix printers
Epson LQ-570e에 대해서도 마찬가지입니다: 제품 정보 매뉴얼 (8 페이지), 매뉴얼 (12 페이지), 빠른 참조 매뉴얼 (15 페이지), 제품 정보 매뉴얼 (18 페이지), 사양 (2 페이지), 조립 설명서 (8 페이지), 참조 매뉴얼 (34 페이지)

페이지 인쇄

ESC ( t nl n2 dl .d2 d3 (Assign Character Tabie)

selectable with the ESC t n command. This is the table that will be replaced. Valid

corresponding to a registered table. lhii is the table that will replace the table

indicated by Variable d1. Valid Values for d2 are 0, 1,3,7,8, and 9 (see Table 2

0 -1 Italic

Table 1

After using the ESC ( t command, the ESC t n command MUST be sent to select the

table before printing from the new table. For example, the command ESC ( t 3 0 1 3

0 is sent (assign Registered Table 3 (PC950) to Selectable Table 1 (PC437). In order

to print the Q character (ASCII 245), the command ESC t 1 must be sent. In the Basic

programming language, the sequence would be as follows:

LPRINT CHR$(27);7';CHR$(l);

LPRINT CHR$(245)

Some ESC/P2 documentation may illustrate as many as 22 different Registered

Tables. The Registered Tables are a part of the character set, therefore, they are

contained in the Character Generator ROM. The CG ROM differs based upon the

destination country. For thii reason, only the above Registered Tables are available

on LQ-570, LQ-1070, LQ-870 and LQ-1170 printers sold for the U.S. market. Foreign

Character Generator ROMs ARE NOT available in the United States. The following

PSB No: P-0082

Page:

I I 9 I