Acuity Controls Fresco VIA5F 사용자 설명서 및 매뉴얼 - 페이지 3

{카테고리_이름} Acuity Controls Fresco VIA5F에 대한 사용자 설명서 및 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acuity Controls Fresco VIA5F 3 페이지.

User Guide and Manual
VIA / VIA5F Ethernet Switch Installation
DEFAULT SETTINGS
IP Address
Static, set as 10.x.x.x (where x is a
number between 0 and 254)
Subnet Mask
255.0.0.0
Default Gateway
10.0.0.1
VLANs
Disabled (all ports run as untagged on
VLAN ID# 1)
Mgmt VLAN
VLAN ID# 1
PoE Supply
External supply value set to zero watts
(PoE effectively disabled)
Port PoE
Enabled. Above value must be set
>5W before a PoE device will boot
QoS
Off
Port Link
Auto-negotiate
Disabled
DHCP
IGMP
Disabled
Disabled
Art-Net to sACN
Conversion

SPECIFICATIONS

Power Supply: 48 VDC, 100W (when used as PoE source)
ETHERNET:
802.3 10/100/1000BaseT
POE:
802.3af
LLDP:
802.1AB Link Layer Discovery
Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitycontrols.com © 2014-2017 Acuity Brands Lighting, Inc. All rights reserved. 07/03/17
Part No. 912-00014-011
FURTHER CONFIGURATION
All field configuration of the VIA5 models must be done with
DXT Solution Manager software.
Download the software from www.acuitycontrols.com and
install.
Set computer's IP to a static address in the 10.x.x.x range,
with a subnet mask of 255.0.0.0 and default gate-way of
10.0.0.1. No configuration of the computer's DNS settings
should be required. Plug into the VIA5 switch and launch the
configuration software. Discovery will be automatic.
Refer to software documentation for description of configura-
tion options
Page 3