Motorola FOCUS86 사용자 설명서 - 페이지 9

{카테고리_이름} Motorola FOCUS86에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola FOCUS86 18 페이지. Works with focus86 wi-fi home video camera
Motorola FOCUS86에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (38 페이지), 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

6. Add Focus TAG as a Presence Detector

1. Make sure that you have correctly installed the battery on Focus TAG. (see

"Remove Plastic Strip to Power On" on page 6)

2. Run Hubble for Motorola Monitors App on your Android™ or iOS device.

3. Press and hold the pair button on Focus TAG for 5 seconds to begin pairing

it with your Android™ or iOS device.

4. Select your FOCUS86 Camera.

5. Tap to select Presence detection.

6. Put Focus TAG inside the object that you wish to track. Ensure that the

distance between the object and FOCUS86 Camera is not more than 300

feet (91 meters).

7. Enter a name for Focus TAG, such as Amy's school bag and tap Continue.

8. Wait for about 10 seconds for Focus TAG to complete setup.

9. It will take a few minutes to check if presence detection by Focus TAG can

be read by your FOCUS86 Camera.

A green tick appears when set up completes successfully.

10. If setup fails, tap Retry and repeat the steps starting from step 1.

11. To activate presence detection, tap ACTIVATE NOW.

Note

The coverage area for presence detection is approximately 300 feet (91 meters)

between FOCUS86 Camera and Focus TAG.

There is a 1 minute delay before a notification will be sent to you when the target

object moves out or returns to the coverage area.

6.1

Add another Focus TAG

You can pair up to 5 Focus TAGs with your FOCUS86 Camera in your Hubble

Account. To add another Focus TAG, repeat the steps in 6. "Add Focus TAG as

a Presence Detector".

Add Focus TAG as a Presence Detector