Motorola Radius CM200 설치 매뉴얼 - 페이지 29

{카테고리_이름} Motorola Radius CM200에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola Radius CM200 36 페이지. Commercial series

Detection of Noise Sources

9.2

Sources of Noise

Some interference is due to geographic location. This interference does not need to be eliminated

since it is possible for the vehicle to be moved away from the interfering noise source. Noise from

power lines, fluorescent lights, and other vehicles (emitting high levels of radiated noise) are

examples of noise which depend upon location. Make certain that you are not attempting to suppress

noise in a vehicle while it is in a noisy location. If you suspect that your location is noisy, simply turn off

everything in the vehicle except the radio and listen to the remaining ambient noise. If the noise level

is objectionable, you may have to noise suppress the vehicle during a less noisy time of day or in a

different, quieter location.

Check the installed radio for conducted and inducted noise by using an unmodulated signal generator

to supply a clean RF signal through a coaxial cable directly to the antenna connector on the radio set.

This should prevent radiated noise from entering the receiver and masking conducted and induced

noise. Make certain that the signal generator is not microphonic and is placed away from the noise of

the engine and exhaust.

Operate the controls for fans, blowers, power windows, headlamps, turn signals, windshield wipers,

and other electrical accessories. Listen for the presence of noise in the received radio signal. This will

allow the source of the interference to be determined. Some noise sources cannot be turned on and

off at will. These sources will need to be attacked piecemeal on a trial and error basis: alternator

whine, voltage regulators, electric fuel pump, and other possible sources. Remember that induced

noise can result from radio wiring being too close to other vehicle wiring. This problem is most easily

solved by proper cable routing at the time of installation.

Radiated noise must be attacked after conducted and induced noise has been satisfactorily

suppressed. The vehicle ignition system is usually the primary source of this interference.

Antenna placement can be critical in some installations. Remember that static discharge generates

static or radiated noise and will probably be generated only when the vehicle is in motion.

Since radiated noise interference is most noticeable in weak signal areas, it is suggested that

suppression be finalized while listening to a weak "on frequency" signal. (The squelch should be

"open" so that even marginal signals can be heard.)