Acumen Scooter 설치 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} Acumen Scooter에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acumen Scooter 8 페이지. Arkon work light user manual

Operation

T T h h e e v v i i s s u u a a l l i i n n d d i i c c a a t t i i o o n n s s a a r r e e b b a a s s e e d d o o n n t t h h e e a a s s s s u u m m p p t t i i o o n n t t h h a a t t t t h h e e P P i i n n k k

w w i i r r e e ( ( I I n n d d i i c c a a t t o o r r s s ) ) a a n n d d t t h h e e B B l l a a c c k k / / R R e e d d w w i i r r e e s s ( ( L L E E D D ) ) h h a a v v e e b b e e e e n n

c c o o n n n n e e c c t t e e d d ( ( S S e e e e p p a a g g e e 3 3 ) ) . .

The standard key fob has three buttons; Lock, Unlock and Silent.

T T o o A A r r m m t t h h e e s s y y s s t t e e m m . .

Press the Lock button of the fob. The alarm will beep twice and

flash the indicators twice. The system LED will start to flash after 5

seconds and the unit will monitor hot-wire, accessory switch,

movement and nudge. (The system will not arm if the ignition is

switched on).

T T o o D D i i s s a a r r m m t t h h e e s s y y s s t t e e m m . .

Press the Unlock button. The system will give one short beep and

flash the indicators once.

N N O O T T E E If the system gives one long beep this means the alarm has

been sounding. Enter diagnostics mode to find the reason why.

Convenience (Ferry) Mode

In Convenience mode the movement/nudge sensor will cease to function.

With the alarm active, press the Silent button. You will get one long tone and

one flash of the indicators.

If the LED flashes once/per second the movement sensing is active

If the LED flashes once every two seconds, the movement sensing is disabled.

You can 'toggle' between Convenience Mode enabled and disabled by simply

pressing the silent button.

Diagnostics Mode

It is possible to determine the trigger source that caused the alarm to sound.

Only the last reason is recorded.

Diagnostic mode can be accessed two ways;

a. When the alarm is sounding the LED will flash a number of times, pause,

then flash the same number again. This will go 30 seconds until the

system stops sounding.

b. Alternatively, disarm the alarm and then press the silent button. The LED

will flash a number of times and the system will beep the same number of

times. Every time you press the silent button the system will flash/beep in

accordance with the following table.

N N u u m m b b e e r r o o f f

T T r r i i g g g g e e r r R R e e a a s s o o n n

F F l l a a s s h h e e s s / / B B e e e e p p s s

No Triggers in last armed period

Power was interrupted (The SCOOTER does not have

an internal battery but if the power is disconnected

when the unit is armed, and then re-connected it will

give a reaction.)

Ignition turned on or hot-wired

Movement

Accessory switch was operated