Acumen Tempest Cat1 사용자 설명서 - 페이지 5

{카테고리_이름} Acumen Tempest Cat1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acumen Tempest Cat1 12 페이지.

페이지 인쇄

Customising the system

Section 1. Full Mode

To passively arm the system automatically with all functions enabled,

permanently connect the Yellow wire from the alarm to a suitable earth

(ground) point.

. If the movement sensor is active, the system LED will flash once

every second

B. If the system is in Convenience Mode (see section 2), the LED will

flash once every two seconds.

C. If you manually arm the C T1 system within the 50 seconds auto

arm time, by pressing the 'key' button, the system will arm with the

movement sensing active.

Section 2. Convenience Mode

During day to day use of the motorcycle there are times when full

passive arming with movement sensing can be inconvenient e.g. filling

with fuel or parking momentarily while opening a garage door. rming

without movement sensing is called Convenience Mode and can be

achieved automatically when the ignition is switched off or by using the

key fob transmitter depending on how the system has been installed.

. Where the system is installed to arm all sensors automatically

when the ignition is switched off, (i.e. yellow wire permanently

grounded) convenience mode can be selected by pressing 'P' on

the key fob transmitter after the system arms. (Passive arming

takes place 50 seconds after switching off the ignition.

B. To avoid waiting for the system to arm automatically press the 'key'

button once to manually arm the system before the 50

seconds elapses and then the 'P' button to enter

Convenience Mode.

Section 3. Service Mode

There may be times when you really don't want the system on the

motorcycle. Such as when cleaning, or performing service work. The

Tempest C T1 has a service mode which effectively makes the Tempest

C T1 system transparent.

To enter Service Mode, disarm the system, switch on the motorcycle

ignition. With the ignition on press and hold the lock button until the

system gives a 'beep' (two to three seconds). This denotes the system

has entered service mode.

In Service Mode, the alarm will beep once every 2 minutes. (If you get

more than one beep see section 4), and the LED will remain on and will

not flash.

If the alarm is left in Service Mode for over 24 hours, the beep will be

switched off. Remember in Service Mode your motorcycle is totally

unprotected - the LED will serve as a reminder!

If you are storing your motorcycle, and need to move the motorcycle

now and then, we suggest you arm the system and place it into Full

Mode.

To exit from service mode, press the lock button until the alarm beeps.