Toshiba 13PACVG-V 소유자 매뉴얼 - 페이지 2

{카테고리_이름} Toshiba 13PACVG-V에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba 13PACVG-V 8 페이지.

페이지 인쇄

PRECAUTIONS FOR SAFETY

Read the precautions

in this manual carefully

before operating the unit.

● Keep this manual where the operator can easily ﬁnd it.

● Read the precautions in this manual carefully before operating the unit.

● This appliance is intended to be used by expert or trained users in shops, in light

industry and on farms, or for commercial use by lay persons.

● The precautions described herein are classiﬁed as DANGER, WARNING and

CAUTION. They both contain important information regarding safety. Be sure to

observe all precautions without fail.

● Do not install, repair, open or remove the cover. It may expose you to dangerous voltages.

Ask the dealer or the specialist to do this.

● Turning off the power supply will not prevent potential electric shock.

● The appliance shall be installed in accordance with national wiring regulation.

● Means for disconnection from the supply having a contact separation of at least 3 mm in

all poles must be incorporated in the ﬁxed wiring.

● The appliance must be stored in a room without continuously operating ignition sources

(for example, open ﬂames, an operating gas appliance or an operating electric heater).

● In order to avoid ﬁre, explosion or injury, do not operate the unit when harmful gases (e.g.

ﬂammable or corrosive) are detected near the unit.

● Do not expose your body directly to cool or warm air for a long time.

● Do not insert your ﬁnger or any article into the air inlet/outlet.

● When an abnormality (burning smell, etc.) occurs, stop the air conditioner and disconnect

the power supply or turn off the breaker.

● This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless they

have been given supervision or instruction concerning use of the appliance by a person

responsible for their safety.

● The air conditioner must be installed, maintained, repaired and removed by a qualiﬁed

installer or qualiﬁed service person. When any of these jobs is to be done, ask a qualiﬁed

installer or qualiﬁed service person to do them for you.

● Children should be supervised to ensure that they do not play with the appliance.

● Do not use any refrigerant different from the one speciﬁed (R32) for complement or

replacement. Otherwise, abnormally high pressure may be generated in the refrigeration

cycle, which may result in a failure or explosion of the product or an injury to your body.

● Do not use means to accelerate the defrosting process or to clean, other than those

recommended by the manufacturer.

● The appliance shall be stored in a room without continuously operating ignition sources

(for example: open ﬂames, an operating gas appliance or an operating electric heater).

● Be aware that refrigerants may not contain an odour.

● Do not pierce or burn as the appliance is pressurized. Do not expose the appliance to

heat, ﬂames, sparks, or other sources or ignition. Else, it may explode and cause injury

or death.

● Appliance and pipe-work shall be installed, operated and stored in a room with a ﬂoor area

larger than A

min

How to get A

: A

= (M / (2.5 x 0.22759 x h

min

M is the refrigerant charge amount in appliance in kg. h

the appliance in m: 0.6 m for ﬂoor standing/1.8 m for wall mounted/1.0 m for window

mounted/2.2 m for ceiling mounted. (For these units recommend installation height 2.5 m)

● Do not wash the unit with water. It may cause an electric shock.

● Do not use this air conditioner for other purposes such as preserving food, breeding

animal, etc.

● Do not step or put anything on the indoor/outdoor unit. It may cause an injury or damage

the unit.

● Do not touch aluminium ﬁn because it may cause an injury.

● Before cleaning the unit, turn off the main switch or the circuit breaker.

● When the unit won't be used for a long time, turn off the main switch or the circuit breaker.

● It is recommended that maintenance be performed by a specialist when the unit has been

operated for a long time.

● The manufacturer shall not assume any liability for the damage caused by not observing

the description of this manual.

INDOOR UNIT DISPLAY

1 TIMER (White)

2 OPERATION (White)

This appliance is ﬁlled with

R32.

DANGER

WARNING

))

is the installation height of

CAUTION

PREPARATION BEFORE USE

Preparing Filters

1. Open the air inlet grille and remove the air ﬁ lters.

2 . Attach the

ﬁ lters. (see detail in the installation manual).

Loading Batteries (when use wireless operation.)

1. Remove the slide cover.

2. Insert 2 new batteries (AAA type)

following the (+) and (–) positions.

Clock Setup

1. Push

by tip of the pencil.

If timer indication is ﬂ ashing, go to the next step 2.

2. Press

: adjust the time.

3. Press

: Set the time.

Remote Control Reset

Push

by tip of the pencil or

1. Remove the batteries.

2. Press

3. Insert the batteries.

AIR FLOW DIRECTION

FIX

Press

: Move the louver in

the desired vertical direction.

SWING

Press

: Swing the air

automatically and press again to stop.

For horizontal direction, adjust

manually.

Note:

Do not move the louver manually by others.

●

The louver may automation positioning by some operation mode.

REMOTE CONTROL

1 Infrared signal emitter

2 Start/Stop button

3 Mode select button (MODE)

4 Temperature button (TEMP)

5 Fan speed button (FAN)

6 Swing louver button (SWING)

7 Set louver button (FIX)

8 On timer button (ON)

9 Off timer button (OFF)

! Setup button (SET)

" Clear button (CLR)

# Memory and Preset button (PRESET)

$ One-Touch button (ONE-TOUCH)

% High power button (Hi-POWER)

& Power selection button (POWER-SEL)

( Quiet button (QUIET)

) Comfort sleep button (COMFORT SLEEP)

~ Filter reset button (FILTER)

+ Set clock button (CLOCK)

, Check button (CHECK)

- Reset button (RESET)

Note:

The provided Remote Controller is a wireless type, which also can be

●

used as a wire. Please see "How to Connect The Remote Controller

for Wired Operation", located in installation instruction, in case of wired

control is required.

●

In wire operation, remote controller will return to initial condition (PRESET,

TIMER and CLOCK will return to initial condition) when user shutdown

power supply of Air conditioner.

SWING

FAN

(

ONE-TOUCH

FIX

QUIET

POWER-SEL

Hi POWER

COMFORT

SLEEP

)