Toshiba 20A42 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Toshiba 20A42에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba 20A42 37 페이지. Toshiba color television owner's manual 20a42
Toshiba 20A42에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지), 서비스 매뉴얼 (33 페이지), 서비스 매뉴얼 (36 페이지), 소유자 매뉴얼 (19 페이지)

페이지 인쇄

REMOTE CONTROL

POWER

SLEEP

VOL

–

RESET

TV/VIDEO

1. POWER Button - Press to turn on the TV. Press again

to turn off the TV.

2. Direct Channel Selection Buttons (0-9) - Allows direct

access to any channel.

3. CH RTN Button - This button allows you to go back to the

previous channel selected by pressing the CH RTN

button. Press this button again to return to the channel you

were watching.

Before using the remote control, batteries must first be installed.

HOW TO INSTALL BATTERIES

1. Open the battery compartment cover.

2. Install two "AAA" (penlight size) batteries.

3. Replace the battery compartment cover.

3L70101A-E COVER-P.07

CH RTN

RECALL

MUTE

CH +

VOL

ENTER

CH –

–

SET

MTS

CAP/TEXT

1/2

4. SLEEP Button - To set the TV to turn off after a preset

amount of time, press the SLEEP button on the remote

control. The clock will count down 10 minutes each time the

button is pressed in the order of 120, 110, 100, ······ 20, 10,

0. After the sleep time is programmed, the display will

disappear then reappear momentarily every ten minutes to

remind you the sleep timer function is operating. To confirm

the sleep time setting, press the SLEEP button once and the

remaining time will be momentarily displayed. To cancel

sleep time, press the SLEEP button repeatedly until the

display turns to 0.

5. VOL (VOLUME) + / – Buttons - Press the + button to

increase, or the – button to decrease the volume level.

6. MENU Button - Press to display the On-Screen menu

function.

7. SET + / – Buttons - Press to select the desired setting

during On-Screen operations.

8. RESET Button - Press to reset the On-Screen picture

adjustments to their factory preset positions.

9. TV/VIDEO Button - Switches between TV and external

inputs.

10. RECALL Button - When you press this button, the channel

number will appear in the upper right corner of the screen.

Press the button again to remove it from the screen.

11. MUTE Button - To turn off the sound, press this button

once. The TV will be silenced and the symbol MUTE will

appear on the screen. The muting feature can be released

by pressing the MUTE button again or one of the VOL + or –

buttons.

12. CH (CHANNEL) + / – Buttons - Press the + button to

change to a higher numbered channel set into memory.

Press the – button to change to a lower numbered channel

set into memory.

13. ENTER Button - Press to enter or select information for On-

Screen operations.

MTS Button - Switches sound between mono, stereo, and

SAP when receiving broadcasts in stereo or SAP.

15. 1/2 Button - Switches between Channel 1 and Channel 2 in

the Closed Caption mode.

16. CAP/TEXT Button - Press this button to switch between

normal TV and the two Closed Caption modes (captions and

1/2 of full screen text). Closed Captioning will display text on-

screen for hearing impaired viewers.

Use two "AAA" size penlight batteries (supplied) for the

transmitter. The batteries may last approximately one year

depending on how much the remote control is used. For

best performance, it is recommended that batteries should

be replaced on a yearly basis, or when the remote operation

becomes erratic. Do not mix old and new batteries or

different types.

BATTERY PRECAUTIONS

These precautions should be followed when using batteries

in this device:

1. Use only the size and type of batteries specified.

2. Be sure to follow the correct polarity when installing the

batteries as indicated in the battery compartment.

Reversed batteries may cause damage to the device.

3. Do not mix different types of batteries together (e.g.

Alkaline and Carbon-zinc) or old batteries with fresh

ones.

4. If the device is not to be used for a long period of time,

remove the batteries to prevent damage or injury from

possible battery leakage.

5. Do not try to recharge batteries not intended to be recharged;

they can overheat and rupture. (Follow battery

manufacturer's directions.)

5/6/02, 11:33 AM