MSI Codex R 12th 매뉴얼 - 페이지 22
{카테고리_이름} MSI Codex R 12th에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. MSI Codex R 12th 31 페이지.
페이지 인쇄
JCI1: Chassis Intrusion Connector
This connector allows you to connect the chassis intrusion switch cable.
Normal
(default)
Using chassis intrusion detector
1.
Connect the JCI1 connector to the chassis intrusion switch/ sensor on the
chassis.
2.
Close the chassis cover.
3.
Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
4.
Set Chassis Intrusion to Enabled.
5.
Press F10 to save and exit and then press the Enter key to select Yes.
6.
Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1.
Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
2.
Set Chassis Intrusion to Reset.
3.
Press F10 to save and exit and then press the Enter key to select Yes.
JDASH1: Tuning controller Connector
This connector is used to connect an optional Tuning Controller module.
2
6
1
5
1
No pin
3
MCU_SMB_SCL_M
5
VCC5
Trigger the chassis
intrusion event
2
4
MCU_SMB_SDA_M
6
Overview of Components
NC
Ground
21