ARIS LINEARIS 사용 설명서 - 페이지 13
{카테고리_이름} ARIS LINEARIS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ARIS LINEARIS 16 페이지. Damper actuator
페이지 인쇄!
ADVICE
1.
Switch off operating voltage of the actuator and if equipped with gear disengagement,
move this to „Manual" position.
2.
Push hand wheel H into position V and turn in the desired direction. (Control cams
of position switches and potentiometers are also turned with it. Set positions are
retained).
3.
After reaching the desired position let the hand wheel H go (it returns automatically to
its initial position R).
!
ADVICE
6.
Required customer information
6.1
Extraordinary situations
Run frequent testings during operation. Observe especially:
•
Intended use of the actuator (chapter 3.1);
•
unusual noise, heavy vibration or high temperatures;
•
check screws for tight seat;
•
check cable entries, cable glands and blank plugs for tight seat and possible leakness;
•
condition of electric wires.
If failure appear, set the actuator out of order and correct the error.
!
ADVICE
6.2
Troubleshooting and repair
WARNING
CAUTION
!
ADVICE
LINEARIS
The hand wheel may be operated only in power-off condition.
To avoid overrunning position switches and the potentiometer during manual operation, set
the limit positions of the actuator mechanically.
If you can not correct the error, contact an ARIS service person.
More information under: www.stellantriebe.de
Hazardous voltage: Possible stroke!
•
Troubleshooting and repair only by experts!
•
Cut off voltage before opening the actuator.
Moving parts at built-on valves: Possible bruise!
•
Troubleshooting and repair only by experts!
We recommend a repair at the ARIS factory.
More information under: www.stellantriebe.de
V
R
H
Y
13