Arista ALC-CMP-DT-BT 설치 지침 - 페이지 3
{카테고리_이름} Arista ALC-CMP-DT-BT에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Arista ALC-CMP-DT-BT 4 페이지.
페이지 인쇄TROUBLESHOOTING
Symptom
During installation, the ARISTA Mobile App
can't find the sensor when scanning for
devices in the area
Sensor is energizing the lights without motion
being detected in the space
Sensor doesn't detect motion when person
enters the space
Sensor's Red LED is on solid
Sensor is de-energizing the lights while
occupants are still in the space moving
Sensor leaves the lights energized long after
occupants have left the space
•
Verify power is supplied to the sensor
•
Verify the switch on the back of the sensor is in the 24 V position
•
Make sure the Blue LED is blinking slowly. If not, the sensor could already be provisioned into
another area. If this is incorrect, factory reset the device by pressing and holding the reset
button for more than 10 seconds
•
Make sure the phone/tablet and sensor are within 30 feet of each other
•
Verify zone configuration using the ARISTA Mobile App is correct
•
Verify sensor configuration (i.e. – wired vs. wireless)
•
Sensitivity may be set too high. Using the ARISTA Mobile App, lower the sensors sensitivity
setting
•
Change mounting location
•
Verify power is supplied to the sensor
•
Verify the switch on the back of the sensor is in the 24 V position
•
If Blue LED is blinking slow, the sensor hasn't been provisioned into the zone using the ARISTA
Mobile App and will not operate properly
•
Verify the sensor is detecting motion by walking underneath the sensor and verifying the
Green LED blinks briefly
•
Sensitivity setting may be set too low. Using the ARISTA Mobile App, increase the sensors
sensitivity setting
•
Verify sensor configuration (i.e. – wired vs. wireless).
•
Verify sensor configuration (i.e. – time delay)
•
Change mounting location
•
Replace Sensor
•
Change mounting location
•
Sensitivity setting may be set too low. Using the ARISTA Mobile App, increase the sensors
sensitivity setting
•
Verify sensor configuration (i.e. – time delay)
3