Arista ALC-DH-BT 설치 지침 - 페이지 3
{카테고리_이름} Arista ALC-DH-BT에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Arista ALC-DH-BT 4 페이지. Daylight harvester sensor
페이지 인쇄
TROUBLESHOOTING
Symptom
During installation, the ARISTA Mobile App
can't find the sensor when scanning for
devices in the area
Sensor's Red LED is blinking once every 30
seconds
Sensor's Red LED is on solid
24 V Powered
•
Verify power is supplied to the sensor
•
Verify the switch on the back of the sensor is in the 24 V position
•
Make sure the Blue LED is blinking slowly. If not, the sensor could already be provisioned into
another area. If this is incorrect, factory reset the device by pressing and holding the reset
button for more than 10 seconds
•
Make sure the phone/tablet and sensor are within 30 feet of each other
Battery Powered
•
Verify the switch on the back of the sensor is in the battery position
•
Verify good battery; and good installation of battery
•
Make sure the Blue LED is blinking slowly. If not, the sensor may be asleep (to conserve
battery). To wake up a sleeping sensor, press the button (for less than 5-seconds).
Battery Powered
•
Replace battery
24 V or Battery Powered
•
Replace Sensor
3