Pioneer A-676 사용 설명서 - 페이지 14

{카테고리_이름} Pioneer A-676에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer A-676 16 페이지. Stereo amplifier
Pioneer A-676에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 사용 설명서 (32 페이지)

페이지 인쇄

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions.

If you think that there is something wrong with this component,

check the

points below. Sometimes the trouble may lie in another component.

Investigate the other components and electrical appliances being used.

If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service cemer or your dealer

to carry out repair work.

Symptom

Cause Remedy

• Power plug is disconnected from outlet.

• Insert plug securely into outlet.

has been plugged

• Turn on power to the other component.

er outlet (e.g. timer,

etc.) but power to that unit is disconnected.

• Connecting cords are disconnected from jacks,

• Connect securely.

• Jacks, or connecting cords pin plugs are dirty.

• Clean jacks and plugs.

h or ADPT 1/

• Set switches correctly (PHONO, TUNER, CD,

s not match the

LINE, DATITAPE 1, TAPE 2). Set the ADPT 1/

TAPE 3 to OFF.

is incorrect.

• Consult the operating instructions for the other

components.

h is set to "OFF."

• Set the switch to "A,"

"B" or "A

B."

OFF" position

• Set PHONO EO button to "ON"

position.

n A-777).

• Shol1ing bars are not inserted into the ADPT 2

• Insert the shorting bars properly.

• Volume control set to

"00"

position.

• Increase volume level from

"00"

position.

r lit). (A-777 only)

• Turn off the muting button (indicator off).

• Connecting cords or speaker cords are

• Connect securely.

• BALANCE control has been adjusted to one side.

• Adjust BALANCE control to center position.

• The position of REC SELECTOR switch is

• Set switch correctly

(See section "RECORDING TAPES").

• Reconnect properly.

s incorrect.

• Consult the operating instructions for the

cassette deck.

• The position of REC SELECTOR switch is

• Set switch correctly

(See section "COPYING TAPES").

incorrect.

• Consult the operating instructions for the

cassette decks.