ABB SPACOM 300 운영 매뉴얼 - 페이지 4

{카테고리_이름} ABB SPACOM 300에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB SPACOM 300 8 페이지. Relay retrofit program cutting tool

R E L AY R E T R O F I T P R O G R A M C U T T I N G T O O L O P E R AT I N G G U I D E S PA C O M 3 0 0

—

3. Operating the cutting tool on a horizontal edge

3.1

3.2

3.3

Ensure that the cutting head is set in the correct

position. The text HORIZONTAL Up and Down must

point in the direction you are cutting.

Make four punches, side by side.

Ensure that you use the correct guiding,

before each cutting cycle.

After each cutting cycle, ensure that thecutting head

is clear of offcut!