Xerox DocuPrint N40 빠른 설치 - 페이지 6

{카테고리_이름} Xerox DocuPrint N40에 대한 빠른 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuPrint N40 10 페이지. Supplies/options
Xerox DocuPrint N40에 대해서도 마찬가지입니다: 기능 설명서 (15 페이지), 보충 설명서 (2 페이지), 기술 지침 (10 페이지)

페이지 인쇄

Install the Finisher

Pass the finisher GFI power cord behind

the Emissions Bracket Assembly and plug it

into the printer, as shown.

X e r o x D o c u P r i n t N 2 4 , N 3 2 , a n d N 4 0 F i n i s h e r

Hold the Paper Transport parallel to the

ground and unfold the two brackets under

the Paper Transport edge nearest to the

printer by pulling on the green tabs. Rotate

them into place by turning them down and

to the side as shown and push them snugly

against the retainers.

CAUTION: Use caution when moving

the finisher to ensure that it does not

tip over.

Slide the finisher towards the printer until

its GFI power cord and connector cable can

easily reach the printer.

Fully extend the Guide Rail that is attached

underneath the printer and align it with the

Guide Rail slot under the finisher. Make

sure the Guide Rail is completely inserted

into the guide rail slot under the finisher

and is aligned with the plate and hole

underneath the right hand side of the

finisher.

Attach the finisher connector cable to the

rear of the printer as shown.