Xerox Phaser 750DP 서비스 매뉴얼 - 페이지 6

{카테고리_이름} Xerox Phaser 750DP에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 750DP 40 페이지. Digital color printer / copier
Xerox Phaser 750DP에 대해서도 마찬가지입니다: 사양 (2 페이지), 브로셔 및 사양 (4 페이지), 참조 매뉴얼 (8 페이지), 매뉴얼 (9 페이지)

페이지 인쇄
Xerox Phaser 750DP 서비스 매뉴얼

Status Code Entry Table 1

Procedure
Go to the Status Code Entry Table, below
Status Code Entry Table
Status
Code
02-282,
The control logic sensed a communications failure between the UI (User Interface) PWB and the LED Switch Panel
283, 330
PWB (282), the Edit Pad PWB (02-283) or the AIFU PWB (02-331).
Initial action:
Switch off the machine power.
If there is other equipment close by that may be generating electrical noise or radio frequency interference,
power it off also.
Contact Building Maintenance and have them verify the proper voltage at the machine plug.
Clean and inspect all corotrons for defects and ensure they are properly installed Section 5-Repairs.
Power the machine on.
If the problem still exists:
Place a service call.
02-340, 350
The control logic sensed an error in the self test routines of the Ram test (02-340), or the EEP ROM test (02-350).
Initial action:
Switch off the machine power.
If there is other equipment close by that may be generating electrical noise or radio frequency interference,
power it off also.
Contact Building Maintenance and have them verify the proper voltage at the machine plug.
Clean and inspect all corotrons for defects and ensure they are properly installed Section 5-Repairs.
Power the machine on.
If the problem still exists:
Place a service call.
Fault Code Procedures
Description/Direction
5/98
2-6
5750 DocuCare Service Manual