Alderon Industries SurfaceMax 8079 운영, 유지보수 및 설치 매뉴얼

{카테고리_이름} Alderon Industries SurfaceMax 8079에 대한 운영, 유지보수 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alderon Industries SurfaceMax 8079 2 페이지. Pump switch

SurfaceMax

Part Numbers - 8076, 8077, 8078 and 8079

Operation, Maintenance and Installation Manual

Safety Guidelines

1. DISCONNECT ALL ELECTRICAL SERVICE BEFORE WORKING ON OR HANDLING THE PRODUCT.

2. DO NOT USE WITH FLAMMABLE OR EXPLOSIVE FLUIDS SUCH AS GASOLINE, FUEL OIL, KEROSENE,

ETC. DO NOT USE IN EXPLOSIVE ATMOSPHERES.

Description of Operation

The SurfaceMax™ Pump Switch is used to automate a utility/ﬂ oor sucking pump. Set the SurfaceMax™ on the

ﬂ oor and plug the power cord from the pump into the piggyback plug on the switch. Plug the piggyback plug into

a standard 120 VAC wall outlet (the unit will work also work on GFI outlets). When water touches the "On Probe",

the pump will turn on. A 10-second delay timer keeps the pump running when water is no longer touching the

"Off Probes". The time delay feature also prevents rapid pump cycling if the water has ripple or wave action. The

switch is ﬁ lled with epoxy so it can be completely submerged in water and operate properly. The switch is de-

signed to turn on at 0.375" liquid level and turn off at 0.125". Leveling screws are provided and are optionally used

for leveling or to slightly adjust the on and off liquid level set points.

Installation of the SurfaceMax

1. Set the SurfaceMax™ on the ﬂ oor and plug the power cord from the pump into the piggyback plug on the

switch (Fig. 1A).

2. Plug the piggyback plug into a standard 120 VAC wall outlet (also works on GFI outlets) (Fig. 1B).

IOM000012A_SurfaceMax Pump Switch | August 16, 2016 12:31 PM

Alderon Industries • PO Box 827 Hawley, MN 56549 • P: 218-483-3034 • F: 218-483-3036 • alderonind.com

Pump Switch

™

Introduction

Before proceeding with the installation or operation of the product, make sure to

read all instructions thoroughly, as well as complying with all Federal, State and

Local Codes, Regulations and Practices. The product must be installed by qual-

iﬁ ed personnel familiar with all applicable local electrical and mechanical codes.

Refer to the National Electrical Code (NFPA 70). Failure to properly install and

test this product can result in personal injury or equipment malfunction.

Pump Switch

™

(Fig. 1)

(1A)

(1B)

Installation Instructions | Page 1