Alderon Industries 7039 사용자 설명서 - 페이지 6

{카테고리_이름} Alderon Industries 7039에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alderon Industries 7039 16 페이지. Cast iron cable weight control and pump switches

페이지 인쇄

Cast Iron Cable Weight - USER GUIDE

Installation

DISCONNECT ALL POWER SOURCES WHEN INSTALLING OR SERVICING THIS PRODUCT. FAILURE TO

TURN OFF ALL POWER SOURCES COULD RESULT IN SERIOUS INJURY OR DEATH.

Installing Float Switch Cable

STEP 1: REMOVE SCREWS

Remove the two screws from the front of the cable weight by

unscrewing until they release from the screw holes (1A) and pull

directly away (1B).

STEP 2: TETHER LENGTH

Determine the desired activation level, place float switch cable

in the cable slot on the bottom half of the cable weight while the

top half is removed, and tether float switch to the appropriate

length. Refer to the instructions that came with the float switch

for recommended tether length guides to determine activation

or pumping range.

Note*: When installing the cable weight, make sure the narrow

end is facing up to ensure proper operation of the float switch

and prevent debris from collecting on the cable weight.

(*) Correct installation position

example, narrow end up.

6 | Alderon Industries™ - Leading Edge Control Products

Control Switches (Narrow Angle)

Minimum recommended tether length is 6 inches

Pump Switches (Wide Angle)

Minimum recommended tether length is 6 inches

Tether

Length