Yamaha ARIUS YDP-S34 소유자 매뉴얼 - 페이지 31

{카테고리_이름} Yamaha ARIUS YDP-S34에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha ARIUS YDP-S34 40 페이지.
Yamaha ARIUS YDP-S34에 대해서도 마찬가지입니다: 빠른 작동 매뉴얼 (2 페이지), 미디 레퍼런스 (14 페이지)

페이지 인쇄
Yamaha ARIUS YDP-S34 소유자 매뉴얼

Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct orientation. Please assemble the unit in
accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the unit on a hard and flat floor with ample space.
• Be sure to use the correct screw size, as indicated below.
Use of incorrect screws can cause damage.
• Be sure to tighten all screws upon completing assembly of
the unit.
• To disassemble, reverse the assembly sequence given
below.
Have a Phillips-head (+) screwdriver of the appropriate size
ready.
Remove all parts from the package and make sure you
have all of the items.
Cord holder
D
Bundled pedal cord inside
1
6 x 25 mm long screws x 4
2
6 x 20 mm long screws x 2
3
6 x 16 mm short screws x 4
4
4 x 12 mm thin screws x 2
5
4 x 20 mm tapping screws x 2
* The two anti-fall brackets are identical. (Either one can be used
for left or right.)
* The adaptor may not be included, or may look different from the
illustration above, depending on your particular area. Please
check with your Yamaha dealer.
A
B
E
C
AC adaptor x 1
6
Caps x 2
7
Anti-fall brackets x 2
1.
Attach (finger-tighten) C to D and E.
1-1
Untie and straighten out the bundled pedal
cord.
Don't discard the vinyl tie. You will need it later in
step 6.
1-2
Align D and E with each end of C.
1-3
Attach D and E to C by finger-tightening
the long screws
2
D
1-3
2.
Attach B.
Depending on the model of digital piano you
purchased, the surface color of one side of B may
be different from the other side. In this case,
position B so that the side of the surface color
similar to D and E faces the player.
2-1
Attach the top of B to D and E by finger-
tightening the thin screws
2-2
While pressing on the lower part of D and E
from the outside, attach the anti-fall
brackets
and then secure the bottom ends
7
of B using four long screws
2-3
Insert the other two tapping screws
20 mm) into the other two screw holes to
secure B.
2-4
Securely tighten the screws on the top of B
that were attached in Step 2-1.
(6 x 20 mm).
1-2
C
E
(4 x 12 mm).
4
(6 x 25 mm).
1
(4 x
5
YDP-S34 Owner's Manual
31