Yamaha AX-10 소유자 매뉴얼 - 페이지 10
{카테고리_이름} Yamaha AX-10에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha AX-10 13 페이지. Natural sound stereo integrated amplifier
Yamaha AX-10에 대해서도 마찬가지입니다: 소유자 매뉴얼 (6 페이지), 소유자 매뉴얼 (6 페이지)
페이지 인쇄
Standby mode
While the power is on, pressing the POWER key on the remote
control transmitter switches the unit to the Standby mode. (In
this mode, the indicator is half illuminated.)
Note
The POWER switch on the front panel of this unit should
be turned off when left unused for a long period of time.
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER
Battery installation
3
2
Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
Use only AA, R6, UM-3 batteries for replacement.
Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
Remove the batteries if the remote control transmitter will
not be used for an extended period of time.
If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.
10
1
POWER
POWER on mode
Remote control transmitter operation range
Remote control
sensor
Notes
There should be no large obstacles between the remote
control transmitter and the main unit.
If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid
direct lighting.
POWER
Standby mode
Within approximately
6 m (19.7 feet)