Yamaha C115V 소유자 매뉴얼 - 페이지 6
{카테고리_이름} Yamaha C115V에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha C115V 11 페이지. Speaker system and subwoofer
Yamaha C115V에 대해서도 마찬가지입니다: 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (37 페이지)
페이지 인쇄
Suspended and Bracket Installation
• Consult an installation expert to arrange for installation or construction work.
• Choose suspension wire, an installation location, and mounting hardware that are strong enough to support the
weight of the speaker.
• Some fittings may deteriorate over extended periods of time due to wear or corrosion. For safety the installation
should be checked thoroughly at regular intervals.
Yamaha cannot be held responsible for damage or injury caused by insufficient strength of the support structure or improper
installation.
I Suspended Installation
The C112VA and C115VA can be used in suspended "flying"
rigs by using an appropriate suspension wire.
1. Replace the bolts with the supplied eyebolts (3/8") as shown
in the diagram, and then suspend the speaker using an
appropriate wire.
Bolts
Eyebolts
• Use only the supplied eyebolts.
• Use two or more eyebolts for suspended installa-
tion. Always use the eyebolts marked
• Do not suspend a speaker from another suspended
speaker.
2. The speaker angle can be adjusted for optimum coverage by
adjusting the lengths of the suspension wires, but the down-
ward tilt angle must be less than 45 degrees, as shown in the
diagram.
6
Bolts
Eyebolts
Maximum
45 Degrees
I Bracket Installation
The C112VA has bracket-mounting screws on the top, bottom,
and sides of the speaker enclosure. The C112VA can be
mounted on a wall or ceiling using the optional brackets listed
below.
Wall bracket
Ceiling bracket
Baton bracket
.
Bracket
Model
BWS251-300, BWS251-400
BCS251
BBS251
• Use only the specified screws (W5/16")
to attach the bracket to the speaker.
The mounting screws are installed on the speaker
when it leaves the factory. Refer to the instruc-
tion manual supplied with your bracket for
installation details.
Screws (W5/16")