Yamaha YSP-CU2700 빠른 참조 매뉴얼 - 페이지 16
{카테고리_이름} Yamaha YSP-CU2700에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YSP-CU2700 21 페이지.
페이지 인쇄
- 1. Important Safety Instructions
- 2. Supplied Accessories
- 3. Preparing Remote Control
- 4. Installing the Batteries
- 5. Recommended Place for Installation
- 6. Example for Installing the Unit
- 7. Installing the Stands
- 8. Raising the Antenna
- 9. Connecting a TV and BD/DVD Player
- 10. Turning on the Unit
- 11. Auto Setup for Appropriate Surround Effects (Intellibeam)
- 12. Installing the Intellibeam Microphone
- 13. Playback with Surround Sound
- 14. Enjoying Three-Dimensional Surround Sound (CINEMA DSP)
1 2 3 4 5
SYSTEM
MEMORY
ENTER
RETURN (
16
d Auto setup for appropriate surround effects (IntelliBeam)
En
4
Press the ENTER key to start the AUTO SETUP
procedure and then leave the room within 10
seconds.
The screen
changes
automatically as
measurement
progresses.
)
If the AUTO SETUP procedure is complete, this unit rings
the chimes.
• The AUTO SETUP procedure takes about 3 minutes.
• To cancel the AUTO SETUP procedure after it is started, or if you do not
want to apply the results, press the RETURN (
• If an error occurs, an error buzzer sounds and an error message is
displayed. For details on error messages, see page 36 in the Owner's
Manual.
5
Press the ENTER key.
The measurement results are applied and saved in the unit.
• You can save several measurement results by pressing
the SYSTEM MEMORY 1, 2, or 3 key.
When the SYSTEM MEMORY 1 key is pressed, "M1
Saving" is displayed, and settings are saved.
• If ambient noise is picked up after measurement begins,
an error message is displayed in the "AUTO SETUP
) key.
COMPLETE" screen prompting you to begin
measurement again. Press the ENTER key to exit the
error message screen, and begin measurement again.
• See page 46 in the Owner's Manual for more information on the system
memory function.