Zanussi ZDTS401 사용자 설명서 - 페이지 12

{카테고리_이름} Zanussi ZDTS401에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZDTS401 20 페이지.

페이지 인쇄

Fill the detergent dis-

penser (A) with deter-

gent.

Multitab function

The multitab function is for combi detergent tablets.

These tablets contain agents such as detergent, rinse

aid and dishwasher salt. Some types of tablets can

contain other agents.

Do a check if these tablets are applicable for the local

water hardness. Refer to the instructions from the man-

ufacturer.

When you set the multitab function, it stays on until you

deactivate it.

The multitab function stops automatically the flow of

rinse aid and salt. The rinse aid indicator light and salt

indicator light are deactivated.

The programme duration can increase if you use the

multitab function.

Activate or deactivate the multitab function before

the start of a washing programme.

You cannot activate or deactivate the multitab function

when the programme operates. Cancel the washing

programme, then set the programme again.

To activate the multitab function:

• Press the multitab button. The multitab indicator light

comes on.

To deactivate the multitab function:

• Press the multitab button. The multitab indicator light

goes off.

Do these steps if the drying results are not

satisfactory:

1. Fill the rinse aid dispenser with rinse aid.

If you use a washing pro-

gramme with prewash

phase, put more deter-

gent in the prewash de-

tergent compartment (B).

Different brands of detergent dissolve in different

times. Some detergent tablets do not have the

best cleaning results during short washing pro-

grammes. Use long washing programmes when you

use detergent tablets to fully remove the detergent.

2. Activate the rinse aid dispenser.

3. Set the rinse aid dosage to position 2.

• You can only activate or deactivate the rinse aid

dispenser when the multitab function is activated.

To activate/deactivate the rinse aid dispenser:

1. Switch on the appliance.

2. Make sure that the appliance is in setting mode.

3. Press and hold function buttons B and C.

– The indicator lights for function buttons A, B, and

C start to flash.

4. Press function button B.

– The indicator lights for function buttons A and C

go off.

– The indicator light for function button B contin-

ues to flash.

– The digital display shows the setting.

5. Press function button B again.

– The digital display shows the new setting.

6. Switch off the appliance to save the operation.

Rinse aid dispenser de-

activated

Rinse aid dispenser acti-

vated