Zanussi ZFT10210WA 사용자 설명서 - 페이지 9
{카테고리_이름} Zanussi ZFT10210WA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFT10210WA 16 페이지.
Zanussi ZFT10210WA에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)
페이지 인쇄
Problem
It is too cold inside the
freezer
The appliance does not
work at all. Neither cooling
nor lighting works
The appliance does not
cool at all
Green indicator flashing
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
Technical data
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
www.zanussi.com
Possible cause
Temperature regulator may be set
incorrectly
Plug is not connected to the mains
socket properly
Power does not reach the appli-
ance
The appliance is not switched on
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Plug is not connected to the mains
socket properly
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
The appliance is not switched on
Temperature Regulator is not on
Temperature sensor problem
Height
Width
Depth
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical de-
vice to the power outlet
Switch on the appliance
Call an electrician
Connect the mains plug properly
Call an electrician
Switch on the appliance
Check the Temperature Regulator
Call the service personnel
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
850 mm
595 mm
635 mm
13 h
230 V
50 Hz
Solution
9