Zanussi ZFT710W 사용자 설명서 - 페이지 9
{카테고리_이름} Zanussi ZFT710W에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFT710W 16 페이지. Freezer
Zanussi ZFT710W에 대해서도 마찬가지입니다: 사용자 설명서 (41 페이지)
페이지 인쇄
Problem
It is too cold inside the
freezer
The appliance does not
work at all. Neither cooling
nor lighting works
The appliance does not
cool at all
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
Technical data
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
www.zanussi.com
Possible cause
Large quantities of food to be fro-
zen were put in at the same time
Food placed in the appliance was
too warm
Products to be frozen are placed
too closely to each other
Temperature regulator may be set
incorrectly
Plug is not connected to the mains
socket properly
Power does not reach the appli-
ance
The appliance is not switched on
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Plug is not connected to the mains
socket properly
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
The appliance is not switched on
Height
Width
Depth
Insert smaller quantities of food to be
frozen at any one time.
Allow food to cool to room tempera-
ture before storing.
Place the products in a way so that
cold air could circulate among them
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical de-
vice to the power outlet
Switch on the appliance
Call an electrician
Connect the mains plug properly
Call an electrician
Switch on the appliance
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
850 mm
550 mm
612 mm
22 h
230-240 V
50 Hz
Solution
9