Zanussi ZFU25113WA 사용자 설명서 - 페이지 7
{카테고리_이름} Zanussi ZFU25113WA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFU25113WA 13 페이지.
페이지 인쇄
Problem
The compressor operates
continually.
The compressor does not
start immediately after press-
ing the QuickFreeze or after
changing the temperature.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
Door does not open easily.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Possible cause
Temperature is set incorrect-
ly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The QuickFreeze function is
switched on.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The QuickFreeze or Quick-
Chill function is switched on.
The temperature regulator is
not set correctly.
The food products tempera-
ture is too high.
The QuickFreeze function is
switched on.
You attempted to re-open the
door immediately after clos-
ing.
Solution
Refer to "Operation"/"Control
panel" chapter.
Wait a few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "QuickFreeze function".
The compressor starts after
some time.
Attach the melting water outlet to
the evaporative tray.
Switch off QuickFreeze or
QuickChill manually, or wait until
the function resets automatically
to set the temperature. Refer to
"QuickFreeze or QuickChill func-
tion".
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Refer to "QuickFreeze function".
Wait a few seconds between
closing and re-opening of the
door.
7