Zanussi ZCG560G 사용자 설명서 - 페이지 17

{카테고리_이름} Zanussi ZCG560G에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZCG560G 20 페이지. Zanussi zcg560g cooker user manual
Zanussi ZCG560G에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

• If you change from liquid gas to natural gas,

undo the by-pass screw approximately 1/4 of

a turn.

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the minimum

position.

Oven injector replacement

1. Remove the bottom plate of the oven cavity

(A) to get access to the oven burner (B).

2. Release the screw (C) which keeps the

burner in position.

3. Carefully move the burner off the injector

support (D).

Slowly move it to the left side. Make sure

that the burner bush stays on the burner

mouthpiece. Do not apply force to the wire

of the thermocouple conductor (F).

4. Release the injector (D) with a 7 mm sock-

et spanner and remove it. Replace it with

the necessary one.

5. Assemble the burner in opposite se-

quence.

6. Replace the gas type sticker near the gas

supply ramp with the one related to the

new gas type.

Minimum level adjustment of the gas

oven burner:

www.zanussi.com

1. Remove the oven control knob.

2. Adjust the adjustment screw (A) with a

thin-bladed screwdriver.

Change of the type

of gas

From natural gas to

liquid gas

From liquid gas to

natural gas

3. Attach the oven control knob.

4. Light the oven burner. Refer to "Gas oven

cooking: Ignition of the gas oven burner".

5. Set the oven control knob to maximum and

let the oven heat for a minimum of 10 mi-

nutes.

6. Turn the oven control knob from maximum

to minimum.

Control the flame. If the flame goes out, do the

procedure from point 1 to point 6 again. There

must be a small regular flame on the oven burn-

er crown.

The manufacturer declines liability if you

do not obey these safety measures.

Levelling

Use small feet on the bottom of appliance to

set same level of cooker top surface with other

surfaces

Adjustment of the

adjustment screw

Fully tighten the ad-

justment screw in.

Release the adjust-

ment screw approxi-

mately 3/4 of a turn.