Aleko LOCKMASTER L110C 매뉴얼 - 페이지 11

{카테고리_이름} Aleko LOCKMASTER L110C에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko LOCKMASTER L110C 17 페이지.

Setting of

the Control

Board

1. DIP Switches

The DIP switches are

used to set the limit

switch of the opener to

be NO or NC, auto close

time of the gate opener

and fast change the

open/close direction

which is determined by

the position of the gate

opener installed.

DIP Switch #1

DIP Switch #1：ON – NO / OFF –NC

This mode enables user to set the board to work with motor with NC or NO limit switch

NOTE: Factory default setting is NO

DIP Switch #2–#4: Auto close time of the gate opener

DIP Switch #2: ON – 12.5 Seconds OFF – 0 Seconds

DIP Switch #3: ON – 25 Seconds OFF – 0 Seconds

DIP Switch #4: ON – 45 Seconds OFF – 0 Seconds

NOTE: The auto-close function would be disabled if all 3 dip switches are turned to off (factory default

setting).

Setting of the Control Board

Limit switch NC (

) or NO (

normally closed

)

normally open