Alemite 3641 서비스 매뉴얼 - 페이지 13

{카테고리_이름} Alemite 3641에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 3641 14 페이지. Electronic preset metered control valve

페이지 인쇄

1. Meter Programming

Electronic Preset Metered Control Valve

Solenoid

19. Drop Detent Ball (47) into the hole in the Housing.

20. Screw Solenoid (48) into the Housing securely.

21. Carefully push the terminal connector [no polarity] onto the

Solenoid pins.

22. Install Keypad (19) into the holes of the Circuit Board

Assembly.

23. Install Top Case (16) onto the Housing.

24. Install Screws (18) that secure the Housing to the Top Case.

• Tighten the Screws securely.

25. Install one additional Screw (17) that secures the Top Case to

the Housing.

• Tighten the Screw securely.

26. Install and seat each Battery terminal onto Bottom Case (41).

• Make sure each terminal is fully seated.

27. Position the Bottom Case over the Lever and onto the

Housing.

• Route the wiring properly with no kinks.

NOTE: The Bottom Case may contact the Sole-

noid connector. This is permissible.

28. Install Screws (46) that secure the Bottom Case to the

Housing.

• Tighten the Screws securely.

29. Insert the tab of Partition (45) into the Bottom Case.

30. Insert the tabs of Case Cover (44) into the Bottom Case and

over the Partition.

31. Install Screws (43) that secure the Case Cover and the

Partition to the Bottom Case.

• Tighten the Screws securely.

Battery Door

32. Position Battery Door (42) [with batteries] to the Bottom

Case.

33. Insert Screws (43) into the Battery Door.

• Tighten the Screws securely.

Swivel

34. Install Screen (14) and O-Ring (15) into Swivel (13).

NOTE: O-Ring (15) is slightly smaller than O-Ring

(12).

35. Install O-Ring (12) onto the Swivel.

36. Screw the Swivel into the Valve's Housing.

• Tighten the Swivel securely.

Alemite Corporation

Extension and Nozzles

Non-Drip Nozzle (Automatic w/ Manual Lock)

NOTE: Refer to Figure 8 for compo-

nent identification.

1. Install Gasket (55) into Angle Body (54).

2. Install Washer (56) into Screw Assembly (57).

3. Thread the Screw Assembly into the Angle Body.

• Tighten the Screw Assembly securely.

4. Install O-Ring (50) onto Nozzle (49).

5. Install and seat V-Block (51) [heel end first] onto

Stem (52).

6. Install the Stem assembly into the Nozzle.

7. Install Spring (53) into the Stem.

8. Screw the Nozzle assembly into Angle Body.

• Tighten the Nozzle securely.

Extensions

1. Connect the components of the extension

assembly and tighten securely.

2. Screw the extension assembly into Control

Valve (11).

• Tighten the extension securely.

SER 3640

Revision (10-04)