Alemite 3530-B 서비스 매뉴얼 - 페이지 2

{카테고리_이름} Alemite 3530-B에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 3530-B 10 페이지. Electronic grease meter

페이지 인쇄

SER 3530

Installation

WARNING

Prior to installation, the following safety pre-

cautions must be observed. Personal injury can occur.

1. Do not exceed the pressure rating of any component

in the system.

2. Rupture of components can inject grease into skin

and eyes, causing serious injury and possible amputa-

tion. If injured, seek immediate medical attention.

3. Protect all material and air supply lines from puncture

or damage. Check all lines for weak or worn conditions

prior to use.

CAUTION

Prior to meter installation, flush all contaminants by

pumping grease through the gun/system. Jammed

gears, damaged components, and inaccurate readings

can occur.

Apply thread sealant to all male pipe threads upon

installation.

NOTE: Table 3 shows the adapters for installing

the grease meter on grease guns and control

valves.

Maintenance

WARNING

Release all pressure within the system prior to

performing any maintenance procedure.

Repairs should only be performed by a qualified person

using original repair parts.

Read each step of the instructions carefully. Make sure a

proper understanding is achieved before proceeding.

Application

Grease Gun Model

Control Valve Model

575 and 585 Series

500, 525, 550, 555, 555-E

1056 and 4015 Series

6243-J3 and 6679-J3

6243-J3E and 6679-J3E

* Included with Models 3530-B and 3530-C

Revision (11-10)

Meter Model

7421-3

3530 and 3530-A

6320-3

6438

3530-B and 3530-C

Table 3 Electronic Grease Meter Adapters

Battery Replacement

NOTE: All meter values remain in memory.

The batteries should be replaced once the battery icon

appears on the display. See Figure 1.

IMPORTANT: The meter will no longer register

should the battery icon begin to flash.

WARNING

Recycle or discard the used batteries properly.

Do not burn or puncture the batteries. Toxic materials

may be emitted which can cause personal injury.

CAUTION

Avoid touching the flat surfaces of the new batteries.

Skin oils can cause battery deterioration. Clean any sus-

pect battery with alcohol prior to installation.

Install the new Batteries positive terminal first.

• See Page 7.

Metering Gear Replacement

IMPORTANT: Install the gear with the magnets

as shown on Page 7.

Rotate the gear assembly to ensure the gears are

properly positioned.

Changes Since Last Printing

Reinstated battery cap kit

Part No.

340062

Adapter Kit for Alemite Cordless Grease Guns

41531

1/8" NPTF (m) x 1/8" NPTF (m) x 1.00" Long

327899-6

1/8" NPTF (m) x 1/8" NPTF (m) x 1.50" Long

327899-3

1/8" NPTF (m) x 1/8" NPTF (m) x 2.75" Long

306722

1/4" NPTF (m) x 1/8" NPTF (m) x 1.19" long

327033 *

1/4" NPTF (m) x 1/4" NPTF (m) x 1.41" Long

Electronic Grease Meter

Adapters

Description

Alemite, LLC