Alemite 7261 서비스 매뉴얼 - 페이지 3
{카테고리_이름} Alemite 7261에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 7261 5 페이지. Cord reel with rv plug
페이지 인쇄INSTALLATION INSTRUCTIONS
MOUNTING
(FIG. 2)
2
1
3
CAUTION:
Maximum installation height is 16 feet (4.9 m). Do
not exceed this distance.
Ensure that only a qualified electrician installs/ser-
vices this equipment.
1. Unpack and inspect reel for damage. Turn by hand
to check for smooth operation. Check for complete-
ness.
2. Configure reel for top, side or bottom-wind (bottom-
wind for constant tension reels only) electrical cord
dispensing by removing bolts (1) securing guide
arm bracket (2). Determine new guide arm location
and remove corresponding bolts. Position guide
arm bracket to reel and replace bolts.
3. Position reel on floor, wall, or ceiling. Secure into
place, using four (customer supplied) screws or
bolts (3).
ELECTRICAL
WARNING:
Ensure that application does not exceed electrical
rating of reel.
Observe applicable NEC, OSHA, and local electrical
codes when installing this equipment.
1. Connect input cord to proper electric supply.
Alemite, LLC
1-800-548-1191-http://[email protected]
Fig. 2
ADJUSTMENTS
SPRING TENSION
If necessary, adjust spring tension on reel by adding or
removing wraps of electrical cord from spool, one wrap at a
time, until desired tension is obtained. Add wraps to increase
tension. Remove wraps to decrease tension.
WARNING:
When adding wraps of electrical cord, be careful not to
exceed the winding mechanism's spring capacity. Add
just enough wraps of cord to achieve the desired tension.
Damage to the winding mechanism will result if spring
is over-tightened.
Always be aware of spring tension on reel. Exercise
extreme caution.
TROUBLESHOOTING INSTRUCTIONS
2
3
1
10
Troubleshooting of the reel consists of isolating a problem to
a defective electrical cord/work device, brush holder/brushes,
or collector assembly. Refer any other discrepancies only to
an authorized service person or directly to Alemite.
WARNING:
The following procedure directs the technician to
take voltage measurements.
Remember, even low voltage is dangerous and can
cause personal injury or death. Exercise extreme
caution!
Ensure that only a qualified electrician installs/ser-
vices this equipment.
3
SER 7261
4
5
7
6
9
Fig. 3
Revision (6-05)
8