ABB REX 521 운영 매뉴얼 - 페이지 5
{카테고리_이름} ABB REX 521에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB REX 521 20 페이지. Relay retrofit program, cutting tool
3. Cutting order
Figure 4 illustrates the cutting order on the front side of the switchgear door when the cutout is widened to the right.
The left side cutting is symmetrical but to the left.
Ensure the needed free space before starting the cutting procedure.
If offcut gatherer is not used, protect the personnel and the switchgear panel from flying offcuts.
It is recommended to use the gatherer. Figure 4 illus-
trates the needed free space when the gatherer is in use.
If there is not enough free space for the gatherer (see
Figure 5 and Figure 6), the cutting head can be used
without the gatherer. However, safety concerns must be
addressed. As the cutoffs may fly from the cutting head,
make sure to pick up all the cutoffs and clean dust after
the work is completed.
A. 179 mm, new cut-out width
B. 8 mm
C. 254 mm
D. 136 mm, old cut-out width
E. 58 mm
F. 18 mm
G. 100 mm
1. Overlapping
2. Space required for gatherer
(symmetrical when cutting left side)
6.
1.
1
7.
2.
8.
3.
9.
4.
10.
5.
F
Figure 5: Cutting order to the left
A
B
C
D
B
E
A
B
C
D
E
G
Figure 4: Cutting order on the front side of the switchgear door
A
B
C
D
B
E
Figure 6: Cutting order to the right
1.
6.
1
2.
7.
2
8.
3.
4.
9.
F
1.
6.
1
2.
7.
3.
8.
4.
9.
5.
10.
F
C u t t i n g To o l O p e r at i n g G u i d e
5