3Com 3108 코드 매뉴얼 - 페이지 12

{카테고리_이름} 3Com 3108에 대한 코드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3108 16 페이지. Nbx feature codes guide for sip telephones
3Com 3108에 대해서도 마찬가지입니다: 참조 매뉴얼 (2 페이지)

페이지 인쇄
3Com 3108 코드 매뉴얼
12
C
1: F
HAPTER
EATURE
Table 3 NBX Feature Codes
Features
Account Codes
Allow the system to track the
next call that you make.
Call Forward All
Forward all incoming calls to your
specific call coverage point
regardless of the state of your
phone.
Call Forward Busy
Forward all calls to your call
coverage point when your phone
is busy.
C
ODES
Using Codes
Press *
+ 888
+ *
+ account code
+ *
+ telephone number
+ Send
Press *
+ 465
+ *
+ the destination to
forward calls to
+ Send
Persists until you turn
off the feature by
entering * + 465 +
Send.
Press *
+ 466
+ *
+ the destination to
forward calls to
+ Send
Persists until you turn
off the feature by
entering * + 466 +
Send.
Notes
Log in to the NBX NetSet utility and go to Directory >
Account Codes for a list of public account codes or
see your administrator. The Call Reports application
tracks the calls.
On an IP telephone, you can use this code sequence
only before you make the call. You cannot use this
feature during an active call.
If you enter an invalid Account Code, you will receive
an error indication.
If you enter an invalid Account Code, or need to cancel
while entering an Account Code, you must hang up to
restart.
When you specify an external telephone number as the
destination, start by entering 9 or 8 or whatever is
required to access an outside line. Enter a * if a pause
is required between an access code and a destination
number.
You can configure all CFWD Overrides (CFWD All, No
Answer, and Busy) from both feature codes and the
NBX NetSet utility.
To specify the number of rings before the call is
forwarded, log in to the NBX NetSet utility and go to
Call Forward > Call Forward. The default is 4.
When you specify an external telephone number as the
destination, start by entering 9 or 8 or whatever is
required to access an outside line. Enter a * if a pause
is required between an access code and a destination
number.