Discount Car Stereo A2D-GM3 Series 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Discount Car Stereo A2D-GM3 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo A2D-GM3 Series 6 페이지.

Delphi 16-pin plug

3. Connect factory 16-pin plug (See Fig. 2) to 16-pin socket on harness (See

Fig. 3)

16-pin socket

4. Connect harness 16-pin plug (See Fig. 2) to XM socket vacated in step 2.

5. Tap/connect red wire to 12V Accessory supply in vehicle. Use voltmeter

or test light to determine circuit condition and ensure power is only

available when ignition key is in "ACC", 'ON ", "RUN" or "RAP" positions.

Accessory usually available in vehicle fuse blocks.

Under no circumstances should red wire be connected to 12V constant (battery)

Secure module and proceed to next section.

Fig. 2

Fig. 3

Pairing

Pairing process varies among devices but basic steps are the same. This

process is done upon initial install and should not have to be repeated.

Turn ignition and radio "ON"

Check peephole for flashing LED (pairing mode)

Bluetooth Settings

2. Go to device

Scan (Search) for devices

3. Tap

4. Wait for Bluetooth device name to appear and tap:

Subscribers, select Fig. 4, non-subscribers Fig. 5

Note: Some phones allow Bluetooth name change.

and enable

Bluetooth

Fig. 4

Fig. 5