ARO PD05X-X-X-B 운영자 매뉴얼
{카테고리_이름} ARO PD05X-X-X-B에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARO PD05X-X-X-B 12 페이지. 1/2” diaphragm pump
페이지 인쇄
OPERATOR'S MANUAL
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
SERVICE KITS
Refer to Model Description Chart to match the pump material options.
637427-XX for fluid section repair (see page 4).
637428 for air section repair (see pages 6 and 8).
PUMP DATA
Models
. . . . . . . . . . . .
see Model Description Chart for -XXX".
Pump Type
. . . . . . . . .
Air Operated Double Diaphragm.
Material
. . . . . . . . . . . .
see Model Description Chart.
Weight
. . .
PD05A-XAS-XXX-B
PD05A-XSS-XXX-B
PD05R-XAS-XXX-B
PD05R-XSS-XXX-B
Maximum Air Inlet Pressure
Maximum Material Inlet Pressure
Maximum Outlet Pressure
. . . . . . . . . .
Air Consumption @ 40 p.s.i.
Maximum Flow Rate
(flooded inlet)
Displacement / Cycle @ 100 p.s.i.
Maximum Particle Size
. . . . . . . . . . . .
Maximum Temperature Limits (diaphragm / ball / seat material)
E.P.R. / EPDM
. . . . . . . . . . .
HytrelR
. . . . . . . . . . . . . . . .
Nitrile
. . . . . . . . . . . . . . . . .
Polypropylene
. . . . . . . . . . .
Polyurethane
. . . . . . . . . . . .
SantopreneR
. . . . . . . . . . .
TeflonR PTFE
. . . . . . . . . . .
VitonR
. . . . . . . . . . . . . . . .
Dimensional Data
. . . . . . . . . . . . . . . .
Noise Level @ 70 p.s.i., 60 c.p.m.
À The pump sound pressure levels published here have been updated to an Equivalent
Continuous Sound Level (L
) to meet the intent of ANSI S1.13-1971, CAGI-PNEU-
Aeq
ROP S5.1 using four microphone locations.
NOTICE: All possible options are shown in the chart however certain com-
binations may not be recommended, consult a representative or the fac-
tory if you have questions concerning availability.
INGERSOLL RAND COMPANY LTD
D
P.O. BOX 151
ONE ARO CENTER
&
(800) 276-4658
FAX (800) 266-7016
D
1/2" DIAPHRAGM PUMP
1:1 RATIO, METALLIC
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
. . . . .
10.36 lbs (4.70 kgs)
. . . . .
16.57 lbs (7.52 kgs)
. . . . .
8.04 lbs (3.65 kgs)
. . . . .
14.25 lbs (6.46 kgs)
. . . . . . . . .
100 p.s.i.g. (6.9 bar)
. . . . .
10 p.s.i.g. (0.69 bar)
100 p.s.i.g. (6.9 bar)
. . . . . . . . .
1 c.f.m. / gallon (approx.)
. . . . .
12.0 g.p.m. (45.4 l.p.m.)
. . . .
0.039 gallons (0.15 lit.)
3/32" dia. (2.4 mm)
-60_ to 280_ F (-51 to 138_ C)
-20_ to 150_ F (-29_ to 66_ C)
10_ to 180_ F (-12 to 82_ C)
35_ to 150_ F (2_ to 66_ C)
10_ to 150_ F (-12_ to 66_ C)
-40_ to 225_ F (-40_ to 107_ C)
40_ to 225_ F (4_ to 107_ C)
-40_ to 350_ F (-40_ to 177_ C)
see pages 11 and 12
À
. . . . .
75.0 db(A)
D
BRYAN, OHIO 43506-0151
E
2007
CCN 15250384
PD05X-X-X-B
PD05R-XSS-XXX-B
MODEL DESCRIPTION CHART
PD05 X - X X S - X X X - B
Center Section Material
A - Aluminum
R - Polypropylene
Fluid Connection
A - 1/2 - 14 N.P.T.F. - 1
B - Rp 1/2 (1/2 - 14 BSP)
Fluid Caps / Manifold Material
A - Aluminum
S - Stainless Steel
Hardware Material
S - Stainless Steel
Seat Material
F - Aluminum
P - Polypropylene
S - Stainless Steel
Ball Material
A - Santoprene
T - Teflon PTFE
C - Hytrel
U - Polyurethane
G - Nitrile
V - Viton
S - Stainless Steel
Diaphragm Material
A - Santoprene
T - Teflon PTFE / Santoprene
C - Hytrel
U - Polyurethane
G - Nitrile
V - Viton
FLUID SECTION SERVICE KIT SELECTION
EXAMPLE: Model # PD05A-AAS-SAA-B
Fluid Section Service Kit # 637427-AA
RELEASED: 11-10-05
REVISED:
2-28-07
(REV. 03)
PD05A-XAS-XXX-B
Figure 1
PD05A - AAS - S X X - B
637427 - X X
Ball
Diaphragm