3D Hobby Shop Velox VR-1 조립 설명서 - 페이지 6

{카테고리_이름} 3D Hobby Shop Velox VR-1에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Velox VR-1 17 페이지.

페이지 인쇄
6
Your model uses pull-pull cables to actuate the rudder. Please examine the pull-pull system assembly
diagram closely:
Start the pull-pull installation by screwing the ball links onto the pull wire ends 5 to 6 threads. The cables
are already run through the fuselage for you. After you crimp the crimp sleeves onto the wire, place a
small drop of thin CA glue on the crimped joint. Assemble both the right and left cable ends in the rear of
the plane as shown.
Fit the rudder onto the fuselage and glue the hinges using 2 large drops of thin CA glue per hinge.