afx light COMBO-LED 15-1872 사용 설명서 - 페이지 3

{카테고리_이름} afx light COMBO-LED 15-1872에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. afx light COMBO-LED 15-1872 15 페이지.

MOUNTING

Orientation

This fixture may be mounted in any position, provided there is adequate room for ventilation

It is important never to obstruct the fan or vents pathway.

When selecting installation location, take into consideration lamp replacement access and routine maintenance.

Safety cables must always be used.

Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or

restricted ventilation.

If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer

or his service agent or a similar qualified person in order to avoid a hazard.

Make sure the installation position is stable before you fix the light. When the light is reverse hanging, make sure the

light will not fall from the truss, use the safety cable go through the truss and bracket of the light as a supporting, to

avoid the light to fall down. There is no entrance to the work area during mounting. Periodically check if the safety

cable has fretted away or clamp is loosened. We will not take any responsibility for damages caused by a badly

installed unit.

Power Supply and Signal Cable Connection

1. Mains Power connection

The exclusive plug should be used between the connection of unit and power. Please ensure that the rated voltage

and frequency are accordance with the power supply. The required input voltage and frequency are: 100-240Vac –

50-60Hz

We suggest that every light has an independent switch so that you can turn on or turn off the light randomly.

Note: the ground wire (yellow/green double-color wire) must be safely connected, the electrical installation must be

in accordance with the related standards

CAUTION: When installing the device, make sure there is no highly inflammable material within a distance of

min.5m!

2. Connection of Signal Cable

You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of the slave light.

Connect the DIGITAL OUT socket of the master and the IN socket of the slave light, then, connect the OUT socket to

the IN socket of the next light. Ordinal to connect all the lights as below:

I N

O U T

The connection between the output of master and input of product, it's available to use the 3 pins XLR cable which

provided by the manufacturer. Signal cable from the DMX output of the controller to the input of the first master light,

and connect to the DMX input of second slave light from the DMX output of the first master light, analogously, till

connected all the slave lights, and insert the last connector to the output of the final light. (Notice: the diameter of

core of every cable should be 0.5mm at least, double core shelter cable should be used).The signal connecting must

use the attached 3 pins XLR cable. Notice, all the internal lead wire of the 3 pins XLR cable should not touch to each

other or connect to the connector.

A DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR connector with a

120Ω resistor between the pin 2 and pin 3 of the XLR connector

COMBO-LED

Page 3