Abbott FreeStyle Libre2 시작하기 - 페이지 3

{카테고리_이름} Abbott FreeStyle Libre2에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Abbott FreeStyle Libre2 9 페이지.
Abbott FreeStyle Libre2에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

4 Get Started

3 Steps

to Apply Sensor

Sensors stick better when you wash, clean, and dry your arm before application.

Wash, Clean, and Dry

Select a site on the back of your upper arm

that stays flat during normal activity. Clean

skin with

non-moisturizing, fragrance-

free soap

and water. Use an alcohol wipe

to disinfect the skin and

let air dry

before

proceeding.

Tip:

Do not use moisturizer

where you apply the sensor.

Apply

Apply the sensor to the back of your

upper arm by pressing firmly. Listen for

the click. Wait 30 seconds and pull back

slowly, leaving the sensor on the skin.

Get support and information

at FreeStyleLibre.us

Parent Tip

Because kids have smaller arms, it can be challenging to find a new sensor

application spot. Make sure to rotate the site to allow skin to fully heal.

Switching arms each time can help.

Prep Applicator

Open sensor by peeling back the lid.

Unscrew cap from the sensor applicator.

Line up marks on the sensor applicator.

Press down firmly and then lift.

Tips to Help Keep

Your Sensor in Place

The FreeStyle Libre 2 system is designed to stay on for up to 14 days.

• Secure sensor by pressing it down and running your finger along the sensor adhesive.

• Apply sensor to different sites each time to avoid irritating your skin.

• Avoid placing sensor on moles, scars, stretch marks, and lumps. Shave hair on arm,

if necessary.

Some people use the following products for extra stickiness and protection:*

Torbot Skin Tac™

Hypoallergenic and

latex-free "tacky" skin barrier

Skin-Prep™ Protective

Barrier Wipe

Protective liquid dressing that

allows skin to breathe so tapes

and films adhere better

Over-bandage†

Be sure to use only medical-grade adhesive, bandage, or tape.

Apply and remove at the same time you apply or remove your

sensor. Leave the opening/hole over the center of the sensor

uncovered so it can breathe.

Parent Tip

Experiment to find extra stickiness products that work for your child.

Try an over-bandage for active kids.

*Abbott Diabetes Care ("ADC") is not affiliated with the manufacturers of the products listed. Reference to third-party products does not constitute or imply an

endorsement, recommendation, sponsorship or favoring of any product or manufacturer. ADC is not responsible for the completeness or accuracy of any information

regarding third-party products. ADC makes no representations, expressed or implied, regarding third-party products or their manufacturers, quality or suitability for

you. Manufacturers' instructions for use of each product should be followed.

†Over-bandage must be applied at the time of sensor application, the opening/hole in the center of the sensor must not be covered. Additional medical grade bandages/

tape can be applied but do not remove bandages/tape once applied until sensor is ready for removal.

Get Started 5

Tegaderm I.V.™

A transparent film that

provides adhesive strength

Mastisol® Liquid

Adhesive

Clear, non-irritating, non-

water-soluble liquid adhesive