Aerial DH20 Series 사용 설명서 - 페이지 6
{카테고리_이름} Aerial DH20 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerial DH20 Series 15 페이지. Condensation dryer
페이지 인쇄Instruction manual condensation dryer DH 10 / DH 20
The marker of the knob points at position "max": the device is in continuous
operation
Attention!
The marks at the rebound curve and the humidity values mentioned above are to be seen as
reference values only. The hygrostat of the air dryer and a hygrometer located inside the room
to be dried most probably will not indicate the same values. It is recommended to change the
setting at the air dryer until the desired room humidity has been reached.
6.3 Condensate outlet
The air dryers of the DH-series are serially equipped with water collecting tanks and with
fittings for 12 mm hoses. If the water collecting tank is used, the appliance will switch off
automatically when the tank is full, and the red pilot lamp will light up.
Attention!
The device switches itself off automatically during withdrawal of the water tank. It will only
starts working again if the bucket adjusted be properly (swimmer on the bucket must osculate
the microswitch in the device). If the device will not start immediately, the bucket should be
moved a little in the device.
If a hose is used for the draining the condensate, it should be proceeded as follows:
Remove the bucket from the bucket compartment.
At the bucket you find a connecting piece . Bore a hole into that connecting piece. Avoid
injuries!
Screw the connecting angle on that connecting piece of the bucket. Don´t forget the
sealing.
In the door of the dryer is a pressed sector. Open this sector to put the hose through after
putting back the bucket into the dryer.
The bottom of the hose must go downwards to leave the unit.
1
-
bucket
2
-
connecting angle
3
-
fastening
4
-
sealing ring
5
-
pipe
without drawing: sealing
It is the seal for the case that you would like no
more to use the tubing. In this way, you can
lock the aperture in the bucket again when you
place the seal under the fastening and turn
firmly this again onto the threaded connecting
piece.
from Serie July 2003
page 5
AERIAL GmbH