Aerial AP 50 사용 설명서 - 페이지 3

{카테고리_이름} Aerial AP 50에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerial AP 50 17 페이지. Swimming pool dehumidifier
Aerial AP 50에 대해서도 마찬가지입니다: 사용 설명서 및 보증 (14 페이지)

페이지 인쇄

1.General advice

You have bought an air dryer made by AERIAL thus deciding for a proven quality

product "Made in Germany". If there are any questions, you will find some advice in

this manual how to eliminate such difficulties as quickly as possible.

ATTENTION:

Immediately after receipt, you should check your air dryer for transport damage! In

the case of damage, you should inform the forwarding agent, parcel service, post

office etc. accordingly upon receipt, and make a note of it on the forwarding

documents!

If a transport damage should be noticed after unpacking the equipment, please

contact immediately your respective seller or specialized dealer.

Before putting your air dryer into operation for the very first time, these instructions

for operation should be studied very thoroughly. Thus, you can make sure that this

appliance will operate perfectly for a long period of time saving yourselves

unnecessary repairs and expenses.

In the case of malfunction disconnect your appliance and ensure that it is not

connected again by taking the mains plug out of the socket.

Please, keep the device wrapping in order to be able to send the device safe for

guarantee repair. In order to save space you open simply the adhesive tape with a

knife and you fold the carton.

2.Mode of functioning

The AP-air dryer is built particularly for air drying in closed rooms. That dehumidifier

can prevent the formation of condensation, eliminate too high air humidity and hold

a specific air humidity constant. The time which the dryer requires in order to

achieve a specific humidity depends essentially on the environmental conditions.

The attainable humidity value is equally dependent on the environmental conditions.

The AP-dehumidifier works according to the condensation principle with heat

recovery. The fan (shown indicatively below) suck the moist air through a cool

condensation here, that the moist air condense as water and flows into a sump. The

chilled and dried air is warmed up at the condenser again. Through the heat pump

effect, the outlet air is some degrees warmer than the sucked room air. Useful

energy can conducted up to 3-fold of the electrical power consumption. The

absolute moisture of air is lowered continuously by the continuous circulation of the

room air through the device. The surplus moisture is removed safely and efficiently.

page 3 of 17