Array Solutions Bandmaster III 매뉴얼 - 페이지 13

{카테고리_이름} Array Solutions Bandmaster III에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Array Solutions Bandmaster III 15 페이지. Universal band decoder

Bandmaster C

onfiguration Software

The Bandmaster III also includes a software utility that can be used to customize the band

segments, set the radio type, interface type, baud rate and radio number.

Run the software utility and select the proper COM port. You may now customize the band

segments by clicking on the band you wish to change. The radio configuration is set by selecting

the desired entries in the radio fields. Click on the Set button to save your changes to the

Bandmaster III.

Establish Communications

It is recommended that you unplug the USB cable from the

decoder before running the configuration software. This makes

it a simple process to identify which COM port the USB driver

assigns to the decoder. Apply power to the decoder and run

the configuration software. Click on the Set COM Port button

to open the Com Ports window. Now plug the USB cable into

the decoder and the assigned COM port should appear in the

COM Port block. If it does not, you may click on the Manual

button and enter the port number. Click on the appropriate port

to select it and then click on the OK button. Select the 4-wire

network address of the decoder. This is #1 for most users.

Now click on the Connect button. If successful, the current

configuration will be loaded and the Communicatinos indicator

will show Ready. You are now ready to begin the configuration

process.

Revision 1.5 November 21, 2011

P a g e

| 13