3D Systems Touch 사용자 설명서 - 페이지 13

{카테고리_이름} 3D Systems Touch에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems Touch 19 페이지. 3d stylus hands on design
3D Systems Touch에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)

페이지 인쇄

HANDLING THE STYLUS

The correct way to hold the stylus:

Proper Handling

Lifting the stylus out of the inkwell:

attempt to pull the stylus straight out as shown on the right.

Proper Handling

Calibrating the device:

The Touch may need to be recalibrated from time to time, particularly if it has lost power or has been moved.

To calibrate the device, place the stylus in the inkwell and start your application. Calibration may take up to a second, so do not

immediately remove the stylus from the inkwell. The LED ring at the base of the Touch device will be lit white when the device is

properly calibrated.

Storing the stylus:

You can rest the stylus on either the desktop or in the inkwell.

NOTE: If you unplug the device or it becomes unresponsive at any point, place the stylus in the inkwell to calibrate the device.

3D Systems, Inc.

Grasp the stylus as you would a pen or pencil. Holding the stylus at the bottom, closer to the orb.

Grasp the stylus and lift up to disengage as shown below in the image on the left. Do NOT

The stylus does not need to be stored in the inkwell.

Improper Handling