3Doodler Flow 사용자 설명서 - 페이지 6
{카테고리_이름} 3Doodler Flow에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Doodler Flow 9 페이지.
페이지 인쇄1.
My pen won't
turn on (the LED
light isn't on)
2.
Plastic won't stick
to the paper, or is
curling up around
the nozzle
3.
Plastic is not
extruding from my
3Doodler Flow
4.
Plastic is leaking
from around the
nozzle
5.
Plastic won't stop
extruding
11/2023
Is the USB-C cord connected
into the power adapter?
Stop extruding and start again using the following
instructions:
Push the nozzle down onto the paper, and then resume
extruding plastic.
Drag the tip of the pen along the paper or surface in a
continuous unbroken line as if you were writing with a
pencil.
Keep your movement slow and steady. The plastic should
hold to the paper and not curl up around the nozzle.
3A.
The plastic is not engaging properly with the drive gear:
With the pen extruding, gently push on the filament spool until
you feel it being pulled through the drive gear on its own.
If the above does not work, reverse the plastic from the pen. (See
Section
4) Snip the ends, flat, avoiding any angles, set the pen to
extrude, reinsert the filament, and try again. If the plastic is too
short to be reversed from the back of the pen, move to 3B.
3B.
The plastic is too short to be removed from the pen:
Tool included
While the pen is on and the nozzle is
hot, unscrew the nozzle using the back
end of the included tool.
The nozzle may loosen with continued usage (or in
transit). While the pen is hot
Light is on), gently turn the nozzle clockwise to tighten
it using the included tool. Stop tightening once you first
feel resistance so as to avoid over-tightening the nozzle
and breaking it.
5A.
Click either speed button once.
5B.
If the pen keeps extruding, disconnect it from the
power supply and then plug it in and try again.
NOTE:
If you have a spare power adapter please use it to test
your 3Doodler Flow. You will need a DC 5V2A power
supply with a USB-C port. This will help determine if
the problem is with your 3D pen or with the included
power adapter. Please make sure the power adapter is
20 watts or lower. This pen will not run on USB-C smart
power adapters.
BLUE or GREEN
Light
Double click either speed button to
set the pen into reverse. Insert the tool
through the front end of the pen and
gently push any excess plastic through
the back of the pen
(BLUE
or
GREEN
LED
SECTION 3: TROUBLESHOOTING
SECTION 3: TROUBLESHOOTING
Tool included
Tool included
6
EN