3DR Video Transmitter Ki 사용자 설명서 - 페이지 2

{카테고리_이름} 3DR Video Transmitter Ki에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DR Video Transmitter Ki 2 페이지. Video transmitter kit

페이지 인쇄

C O NT E NT S

Your 3DR Video Transmitter Kit includes:

5.8GHz 200mW Wireless AV Transmitter Specifications:

• Frequency/channel: 5705-5945 MHz/8 CH

• Output power: 200 mW/33 dBm

• Frequency control: Built-in frequency & phase lock loop

• AV Input: Analog AV signal input

• ANT connector: RP-SMA

• Power supply: DC 7-12 volts

• Current supply: 850 mA

• Dimensions: 68 mm x 26 mm x 28 mm

• Weight: 60 g (incl. antenna)

• Gross weight: 85g

5.8GHz Wireless AV Receiver Specifications:

• Receiving frequency: 5705-5945 MHz/8 CH

• Receiving sensitivity: -90 dBm

• Antenna connector: RP-SMA

• Power supply voltage: DC 7-12 volts

• Supply current: 150 mA

• Dimensions: 61 mm x 52 mm x 13 mm

Antennas (2)

Receiver cables:

DC power cable

AV output cable

C O NT E NT S

Your 3DR Video Transmitter Kit includes:

5.8GHz 200mW Wireless AV Transmitter Specifications:

• Frequency/channel: 5705-5945 MHz/8 CH

• Output power: 200 mW/33 dBm

• Frequency control: Built-in frequency & phase lock loop

• AV Input: Analog AV signal input

• ANT connector: RP-SMA

• Power supply: DC 7-12 volts

• Current supply: 850 mA

• Dimensions: 68 mm x 26 mm x 28 mm

• Weight: 60 g (incl. antenna)

• Gross weight: 85g

5.8GHz Wireless AV Receiver Specifications:

• Receiving frequency: 5705-5945 MHz/8 CH

• Receiving sensitivity: -90 dBm

• Antenna connector: RP-SMA

• Power supply voltage: DC 7-12 volts

• Supply current: 150 mA

• Dimensions: 61 mm x 52 mm x 13 mm

Antennas (2)

Receiver cables:

DC power cable

AV output cable

Wireless AV transmitter

Wireless AV receiver

Transmitter cables:

Red and black two-wire cable

Red, black, and white three-wire cable

Wireless AV transmitter

Wireless AV receiver

Transmitter cables:

Red and black two-wire cable

Red, black, and white three-wire cable

W I R I N G

Wiring the transmitter

Attach an antenna to the transmitter. The red, black, and white

three-wire cable connects the transmitter to the GND, +12V, and

VOUT pins on your on-screen display (OSD) module. The red and

black two-wire cable connects the transmitter to a power source.

Connect battery here

Transmitter wired to battery

and AV input cable

Wiring the receiver

Attach an antenna to the receiver. Connect the AV output cable

to either receiver AV OUT port, and connect the DC power cable

from the DC power port to a power source (shown below with

battery connected).

Transmitter wired to battery and AV output cable