ClearWater Lights Darla 설치 매뉴얼 - 페이지 11
{카테고리_이름} ClearWater Lights Darla에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater Lights Darla 12 페이지. Led light kit for bmw k1600gt
ClearWater Lights Darla에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (16 페이지)
페이지 인쇄
Alignment / Using a Drip Loop
Aligning the Lights:
Ask an assistant to help you with this procedure. Make sure the bike is
on level ground and have an assistant sit on the bike. With a right angle
board or object, position the board on the floor and slide it up to the light.
The goal is to adjust the lights so that the light is level with the ground.
Passengers and luggage may alter the alignment of the light, so further
adjustments may be needed. You may find that a slight downward angle
(5 degrees) is helpful.
Using a Drip Loop:
• Though our lights are sealed for ultimate all weather use, sometimes
water sneaks by. To make sure this doesn't happen, we highly suggest
using a drip loop. When installing the wiring to your lights, use a drip
loop as shown below. This will keep water from dripping directly into the
light and instead fall off before it can reach the back of the body.
• To do this just leave a bit of extra wiring and let it hang below the light.
You could make a complete loop if you like, but just make sure the wire
hangs below the light as shown below.
No Drip Loop
Page 10
With Drip Loop
Page 11