artisan ARTPC-SB2M 조립 지침 매뉴얼 - 페이지 7

{카테고리_이름} artisan ARTPC-SB2M에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. artisan ARTPC-SB2M 8 페이지. Dual side burner mounting bracket for artisan cart models: artpc-26, 32 and 36

페이지 인쇄

STEP 9:

Once the ARTP BBQ and the ARTP-SB2 Dual Side Burner gas been tested for leaks and all burner light up to

your satisfaction, it is time to close up the Side Burner Unit's outside skin panels. (see figure #8)

Install the Back Cover (Item 2 - part # 100-3091 on page 2) by sliding the top section between the ARTP-SB2 pe-

rimeter and the inside support flange. The support flanges are shown on picture 6 on page 5.

Secure the back cover to the rear mounting bracket using (2) 10-32 x 1/2" pan head Philips screws (item 8 - part

200-0267 on page 2) as shown below at the bottom of the back cover.

Route the ARTP-SB2 power cord through the square cut-out hole in the back cover. Secure the cable with the

square strain relief (item 9 - part 210-0259 on page 2) by clamping the cable (close to the square cutout) and

pushing the strain relief into the square hole.

Install the side cover (item 1 - part 100-3090 on page 2) by sliding the top section between the ARTP-SB2 perim-

eter and the inside support flange. The support flanges are also shown on picture 6 on page 5.

Secure the side cover to the rear mounting bracket and front body using (2) 10-32 x 1/2" pan head Philips screws

(item 8 - part 200-0267 on page 2) as shown below at the bottom of the back cover.

POWER CORD

ROUTE

CABLE

SIDE COVER

10-32 SCREWS

CABLE STRAIN

RELIEF

BACK COVER

10-32

SCREWS

Figure # 8