Artist Guitars LP DIY KIT 매뉴얼 - 페이지 5

{카테고리_이름} Artist Guitars LP DIY KIT에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artist Guitars LP DIY KIT 16 페이지.

LP DIY KIT MANUAL

NECK FINISH

The neck of the guitar is supplied sealed with a light coat of matte lacquer

and is ready to use. If preferred, the neck can be ﬁnished with a colour or

gloss lacquer. If so, do the following.

The rosewood ﬁngerboard does not need coating with lacquer, so it is

important to mask off the exposed rosewood and frets prior to spraying.

Ensure all parts to be sprayed are free from dirt and dust and that the

environment is dust-free and well-aired. The use of a dust mask is essential

when spraying.

Choose a good quality, clear or lightly tinted wood lacquer aerosol for the

neck and begin at the front and sides of the headstock. Start with a

gradual, even pass to apply a thin coat, allow drying (to be touchable) and

repeat this two or three times. Take care not to apply too much, which may

cause runs. If this happens, sand down the area and re-apply evenly.

After the headstock has become dry, turn the neck over and lay it down on

its ﬁnger board. Repeat the above process for the rest of the exposed

maple.

Allow two to three days for the lacquer to fully harden and then, if desired,

polish the lacquered surfaces to get a suitable shine.