AluTeam BR 13x-3 조립 지침 매뉴얼 - 페이지 9
{카테고리_이름} AluTeam BR 13x-3에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AluTeam BR 13x-3 14 페이지. Box kits
페이지 인쇄LED strip left
MA 350081
2
1
SML MA 350135
Connector cable MA 350081
Connection cable MA 350161
Blind cap pin MA 350093
1
MA 350172
MA 350173
in the frame
pillar
2
Fig. 361
Fig. 363
A
Fig. 364
Assembly instructions BR 133-3 to 139-3
LED strip right
1
2
MA 350081
Fig. 353
1+2
3
Connection
cable
MA 350081
Fig. 354
Fig. 355
Fig. 362
B
Fig. 365
For the cabling of the LED strips
•
frared sensor), just connect
connection downward into the left frame pillar (Fig. 353).
Remark: The illustration indicates a cabling with LED strips on the
right and left.
•
For the cabling of the preassembled side marking lights (SML), just
1.
connect
the plug on the left side with the connection cable in
the floor profile and
with this cable as well.
Now insert the plug connections no.
on the front or on the side (Fig. 354); see also 3.9 (Fig. 396).
For the reversing camera MA 350172 or MA 350173, connect
•
camera cable in the frame pillar with that of the camera and slide
the plug connection into the pillar (Fig. 355). Then
cable MA 350174 into the driver cab in order to connect it to an
external monitor or via an adapter cable to the vehicle display.
Attention:
Be sure to follow the assembly instructions of the
camera manufacturer, as well as the specifications of
the chassis producer.
3.6 Assembly of the frame, doors, top gate or sliding door
•
Fix the lower cross beam from the outer side of the corner pillars
each with 2 screws M 10 x 60 mm. Do not tighten the screws yet!
Measure the diagonals of the frame and correct these as appropri-
ate until they are in full alignment (Fig. 361).
•
Tighten the screws of the frame nodes M 10 x 20 (MD 100332) and
the bottom frame cross beam screws M 10 x 60 (MD 100328) with
the correct torque (no impact screwdriver!). The cross beam and
the rear surfaces of the pillars must be flush (Fig. 362).
•
Take the fittings out of the roof assembly strips.
•
Close the tailgate in order to check the fit accuracy.
Set these up as appropriate, according to the door design, over the
brace supports on the frame cross beams.
•
Fix an upper flap to the frame using the holes provided in the hinge
with the screws MD 100058. Then seal the transitions (Fig. 363).
Take the gas pressure springs (piston rod must point down) and
engage the spherical heads.
•
In the case of a frame pillar with integrated seal, secure the flap
against lateral displacement with the assembly screws
•
In the case of a frame pillar without integrated seal, secure the flap
against lateral displacement with 2 brackets
•
Mount a sliding door according to the current instruction included
with the assembly material for sliding doors.
Status 03/2022
Former instructions lose their validity.
without
motion detectors (in-
1.
the plugs and slide
2.
connect the plug on the right-hand side
1
2
and
into the floor profile
B
(Fig. 365).
2.
the plug
1.
the
2.
route the
A
(Fig. 364).
9 / 14