Alvin CH300-40DH 조립 지침
{카테고리_이름} Alvin CH300-40DH에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Alvin CH300-40DH 2 페이지. Olympian chair (drafting height)
페이지 인쇄
Tools Required:
Allen wrench
Parts Included:
A
5pcs Casters
E
1pc Seat Post
F
1pc Seat Post Cover
C
1pc Extender
To Assemble:
Unpack and inspect contents to
1
confirm you have all pieces pictured.
Attach five casters (A) to the legs of the
2
wheel base (B) as shown in Figure 1.
Insert the extender (C) into the wheel
3
base, followed by the foot ring (D)
inserted into the extender.
Insert the seat post (E) into the foot ring
4
and cover with the seat post cover (F),
with narrowest part at the top.
Figure 1
D
Olympian Chair
Assembly Instructions
Important:
Tighten them fully once chair is assembled or when instructed.
D
1pc Foot Ring
M
2pcs Armrest
B
1pc Wheel Base
F
E
C
B
A
(Drafting Height)
Keep screws loosely tightened during the assembly process.
H
1pc Seat
G
1pc Back Rest
Place the back rest (G) face up on a clean, flat surface with
5
the attached brackets facing up. See Figure 2.
Position the seat (H) so that the holes are lined up with the
6
holes on the back rest brackets.
Use three metal bracket screws (I) in the middle 3-hole
7
metal bracket to attach the seat and the back rest. Leave
screws loosely tightened until all screws are in place.
Use four seat and back rest bracket screws (J) in the outer
8
back rest brackets to firmly attach the seat to the back rest.
Tighten all screws.
Figure 2
G
Page 1 of 2
For model
CH300-40DH
I
3pcs Metal Bracket Screws
J
4pcs Seat and Back
Rest Bracket Screws
L
4pcs Mechanism Screws
N
2pcs Arm Width Adjustment
Knob and Washers
K
1pc Mechanism
H
J
J
I